Tapered Frame Style Tables

Tapered frame tables have a frame that tapers from top to bottom with the legs attached to the underside of the frame. Due to the type of support required for this type of frame, there are certain necessary features used in ProLine Tables which give added stability.

Mitered corner joints are incorporated into ProLine frames to give you the furniture beauty that you demand when purchasing a fine piece of furniture. This is accomplished by perfectly matching the side and end frames mitered instead of placing a decorative cap over the gap between the sections of wood.

All wood joints and bracing in the corners provide the maximum stability to the corner. Metal bracket corners just simply cannot provide the proper amount of strength needed for good stability.

A factory assembled frame allows for the frame to be pre-leveled at the factory and finished as one unit for consistency in the furniture quality & flatness.

Knock-down frames allow for the frame to be taken apart if necessary to allow access around tight corners such as lofts or basement stairs.

2” x 6” interlocking cross beams are the thickest in the industry and create the maximum stability achievable in a pool table.

Center beams running the length of the table on all sizes provide added support to the frame and additional support points to maintain a perfect level of the table.

ProLine pool tables have solid wood beams for all supports. Many manufacturers use plywood beams for this critical support section.

Straight Frame Style Tables

Straight frame style tables have legs extending all the way from the floor to the slate. The frame sections bolt to the sides of the legs.

One advantage of this style is that the slate rests directly on top of the legs for maximum strength.

ProLine uses 2” x 6” interlocking cross beams to support the slate; these are the thickest in the industry and create the maximum stability achievable in a pool table.

Center beams running the length of the table on 8 ft and 9 ft models provide added support to the frame and additional support points for perfect leveling of the table.

Because the frame sections are bolted to the legs, the possibility of over-tightening is eliminated.

Knock-down frames allow for access into any room for installation. The undersides of the frames are sealed to prevent moisture and humidity from entering the frames, stabilizing the bed are for accurate leveling.